2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 331Get this manual
Section 06 ENGINE MANAGEMENT (4-TEC) Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
Disconnect connectors from idle bypass valve, and TPS Disconnect throttle cableInstallation Installation of the new throttle body is the reverse of the removal procedurePay attention for the following detailsRefill and bleed the cooling system, refer to COOLING SYSTEM subsectionFor TPS and idle bypass valve replacement procedures, refer to the respective paragraph in ELECTRONIC MANAGEMENT belowA32CCIA
Adjustment
TYPICAL
Replacement
Removal To remove the throttle body from engine, proceed as follows: Disconnect air intake silencer from throttle body Drain cooling system Remove clamps and hoses for throttle body heating from nipples Remove retaining screws of throttle bodyR1503motr161A