2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 219Get this manual
Section 04 ENGINE (4-TEC) Subsection 04 (LUBRICATION SYSTEM)
Inspection
Check and clean the oil filter inlet and outlet area for dirt and other contaminationsR1004motr41A
R1004motr55A
1Inlet bore from the oil pump to the oil filter 2Outlet bore to the engine oil providing system
Installation
The installation is the opposite of the removal procedurePay attention to the following detailsNOTE: Slightly oil the two gaskets at the top and bottom sides of the oil filter before assemblyThis will ease assembly and prevent displacement of the gasket during installationAt assembly, remember to replace the two O-rings no6 and no8 of the oil filter screwSlightly grease the O-ring no6 of the oil filter cover before assembly using Molykote 111 (PN 413 707 000)This will ease assembly and prevent displacement of the gasket during installationTorque oil filter screw to Nm (80 lbfin)