2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 218Get this manual
Section 04 ENGINE (4-TEC) Subsection 04 (LUBRICATION SYSTEM)
NOTE: Oil pressure switch works between 20 kPa (2.9 PSI) and 40 kPa (5.8 PSI)The engine oil pressure should be within the following valuesOIL PRESSURE MINIMAL NOMINAL MAXIMAL 1300 RPM 150 kPa (22 PSI) 200 kPa (29 PSI) 250 kPa (36 PSI) 7250 RPM 400 kPa (58 PSI) 450 kPa (65 PSI) 550 KPa (80 PSI)
Inspection
Oil condition gives information about the engine conditionSee TROUBLESHOOTING section
Installation
The installation is the reverse of removal procedurePay attention to the following detailsNOTE: At installation, remember to replace the gasket ring no44 of the drain plugTorque drain plug to 55 Nm (40 lbfft)
System Capacity
Refer to TECHNICAL DATANOTE: After filling, warm up the engine to 80C (176F) and check the oil level with the dipstickRefer to OIL LEVEL CHECK above