2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 193Get this manual
Section 03 ENGINES (2-STROKE) Subsection 10 (FUEL SYSTEM)
A01C5HA
A01C5FA
CHOKE LEVER FULLY OPEN POSITION
Insert choke plunger tool (PN 529 032 100) into choke air inlet of each carburetorTool stopper may not lean against recess wallThough it must be within mm (.040 in) of recess wall
CUT-AWAY (ENGINE SIDE SHOWN) 1Choke plunger 2Tool properly seated under choke plunger
If tool tip does not sit under choke plunger no15, adjust as follows: Make sure choke lever is at fully open positionLift up protector cap and loosen choke cable lock nut, as shown in the next photo