2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 191Get this manual
Section 03 ENGINES (2-STROKE) Subsection 10 (FUEL SYSTEM)
Install clamps in way that their tightening bolts are staggered not aligned
Throttle Cable Circlip at Handlebar
Put silicone grease (PN 293 550 004) around cable barrelLocate circlip as per illustration
At full opening, throttle slide must be flush or 1.0 mm (.040 in) lower than the top of carburetor outlet bore (engine side)Use mirror to look through inlet boreFirst loosen adjuster nut then turn throttle cable adjuster accordinglyWARNING
If this procedure is disregarded, throttle lever might be half-open at normally closed position and the engine will speed up when starting2
A01C3MA
FULL OPENING (THROTTLE LEVER AGAINST HANDLE GRIP) 1Throttle cable adjuster 2Throttle slide flush or 1.0 mm (.040 in) lower than carburetor outlet bore (engine side)