2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 152Get this manual
Section 03 ENGINES (2-STROKE) Subsection 05 (MAGNETO SYSTEM)
420 876 080
Remove grommet from crankcase where trigger coil wire exits magneto housing Remove retaining screws no4 Remove trigger coil and carefully pull wires Install new trigger coil and other parts removed
ASSEMBLY
Trigger Coil
For installation, reverse the removal procedureNOTE: It is important to remove the old silicon at trigger coil location then apply new siliconScrew trigger coil then stick the trigger coil wires in the silicon
A03C1JB
TYPICAL 130 mm socket
Make sure to position stator no6 in way that its wire protectors are over recess of crankcase2 1