2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 25Get this manual
INTRODUCTION
Apply several drops of proper strength Loctite on stud threads Install stud Install cover, etc Apply drops of proper strength Loctite on uncovered threads Tighten nuts as required
Adjusting Screw
Preassembled Parts
A00A3PA
1Apply here 2Plunger
A00A3OA
Adjust screw to proper setting Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces Avoid touching metal with tip of flaskNOTE: If it is difficult to readjust, heat screw with soldering iron (232C (450F))
1Apply here 2Do not apply