2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 22Get this manual
INTRODUCTION
TYPICAL PAGE
Section 05 TRANSMISSION Subsection 03 (DRIVEN PULLEY)
Turn puller handle and sliding half at once to extract the bushing
INSTALLATION
Countershaft
CAUTION: Always apply anti-seize lubricant (PN 413 701 000) on the countershaft before final pulley installation
Title indicates main procedure to be carried-outItalic bold face type setting indicates particular procedure concerning modelItalic bold face setting in this case indicates that particular procedure for and B-Series is finished, so from this point, all models are concernedTYPICAL caption indicates general view which does not represent full detailTOP VIEW caption helps you in understanding illustrationCall-outs for above illustration
529 031 300
A-Series and B-Series Only Should installation procedure be required, refer to BRAKE then look for Brake Disc and Countershaft Bearing AdjustmentReinstall the pulley on the countershaft by reversing the removal procedureAll Models
529 031 200
A03D1YA