2005 Ski-Doo Racing Handbook, Page 339Get this manual
SECTION 06DRIVE SYSTEM
ASSEMBLY
3,5,6, Drive Axle and Sprocket
To assemble press fit sprockets, use press and suitable pipe as illustratedSprockets must be assembled according to the following dimensionsEnsure to align indexing marks of each sprocket when assembling
A24D05A
TYPICAL 1Indexing marks aligned
The maximum desynchronization for the sprockets is 1.5 mm (116 in)To check this tolerance, place axle assembly on plane surface and measure the gap between sprocket tooth and surfaceA33D0MA