2005 Ski-Doo Racing Handbook, Page 307Get this manual
SECTION 06DRIVE SYSTEM
3Tighten the jam nut after the belt adjustment has been madeSee arrow
Too Much Belt Deflection If the belt is too long or the center distance is too short, the initial starting ratio will be too high, resulting in performance lossThis is due to the belt rising too high in the drive clutch sheaves upon engagement(Belt riding below top of sheave
A32D34A A32D3UA
BELT REMOVAL ON TEAM ROLLER SECONDARY
1Thread the belt installation tool (PN 930002) into the open hole next to the belt width adjuster bolt2Thread the tool into the hole until the sheaves separate enough to remove the drive belt(If the tool turns hard, rotate the moveable back and forth to ensure that the roller is not locked in the ER notch