2005 Ski-Doo Racing Handbook, Page 300Get this manual
SECTION 06DRIVE SYSTEM
Take 1st measurement when sliding half begins to turnRotate sliding half to 10 mm (38 in) of rotationHold spring scale at this positionSlowly release tension from spring scale and take nd measurement when sliding half begins to returnSpring pre-load is the average measurement between these 21st measurement (when opening)2nd measurement (when closing)Spring pre-load
3.8 kg (8.4 lb)3.4 kg (7.5 lb) 3.6 kg (8 lb) Example: (when opening) (when closing)Actual spring pre-load 2
A18C0AA
TYPICAL Letters and numbers shown in illustration are actual letters and numbers embossed on parts
1 529 006 500
NOTE: Always recheck torsional pre-load after adjusting
Pulley Alignment and Drive Belt Height
Refer to PULLEY DISTANCE AND ALIGNMENT and DRIVE BELT to perform adjustmentsDrive belt height is adjusted by turning Allen screws no13 equally and accordinglyCAUTION: Drive belt and pulley adjustments must always be checked whenever pulleys have been removed, replaced or disassembled