2005 Ski-Doo Racing Handbook, Page 281Get this manual

2005 Ski-Doo Racing Handbook, Page 281

SECTION 06DRIVE SYSTEM
593 HO Engine Equipped Models Only
A32D1ZA

Always install lever assemblies so that cotter pins are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, drive pulley misbalancing will occur because of levers difference793 Engine Equipped Models Only

A32D1XA

Back to 2005 Ski-Doo Racing Handbook