2005 Ski-Doo Racing Handbook, Page 190Get this manual
SECTION 05ENGINE PREPARATION
Connect other multimeter wire to engine (ground), then place selector switch to and scale to 0.00 Vac1 2
Connect battery negative post to buzzer negative tabSee next photoCAUTION: To avoid buzzer damage, ensure that polarity is respected
A32E11A
1MAG side spark plug cable 2Connected to ground
A32E3SA
Activate the manual starter and check values indicated by the multimeter Repeat operation times Compare readings with those appearing in the IGNITION table
TYPICAL 12-VOLT BATTERY PLUGGED TO BUZZER 1Buzzer positive tab 2Buzzer negative tab