2005 Ski-Doo Racing Handbook, Page 187Get this manual
SECTION 05ENGINE PREPARATION
A30E1XA
CHECK KEYS PROGRAM KEY VEHICLE INFO TA RT H
The reading must be times within or above the range indicated in the corresponding tableIf the reading is too low, the part is considered to be defective and must be replaced Resistance Readings Place multimeter selector switch to in order to measure resistanceReadings must be within the indicated rangeOtherwise, the part is considered to be defective and must be replacedCAUTION: When taking measurements, it is useless to try to start the vehicle since readings would then be distorted Intermittent Ignition Problems It is difficult to make diagnostic in the case of intermittent ignition problemsThus, problems occurring only when the engine operating temperature is normal must be checked in similar conditionsIn most cases when problems are caused by temperature or vibrations, these can only be solved by replacing partsMost problems cannot be detected when the engine is stopped Multiple Problems As matter of fact, more that one component can be defectiveAs result, if the problem remains although part was replaced, start over the whole verification from the beginning in order to identify the other defective component