2005 Ski-Doo Racing Handbook, Page 115Get this manual
SECTION 04SUSPENSION SC-3 SC-4RAS
16Cup your hand and place it over the remote reservoirPump with your hand to circulate oil through the base valve (adjustment system) to remove any trapped airLow speed adjuster must be open turn minimum17Fill the remote reservoir with oilLubricate O-ring seal on floating piston with shock oil and installThe key to good shock performance is to remove all the air from shock body, reservoir, and valve stack
22Again, push the floating piston to the bottom of the remote reservoir23Pull the shock shaft as far out as possible and replace the seal cover and torque to 89-101 Nm (66-74 lbfft)Oil must spill from the shock body before the seal cover O-ring seals the shock24Install the remote reservoir coverInstall the retaining clipPull cover to seat against the retaining clipMake sure the cover is firmly seated against the retaining clip before filling with gas25Install air inlet valve26Pressurize the shock at 2068 kPa (300 PSI) with nitrogenUse the correct needle tool (P 529 035 614)