2005 Ski-Doo Racing Handbook, Page 71Get this manual
SECTION 03CHASSIS PREPARATION
Heating Grip Element
Refer to TESTING PROCEDURE for checking heating element no13 of grip
Ball Joint (left hand and right hand threads)
Inspect ball joint ends no17 and no18 and small tie rod ends for wear or looseness, if excessive, replace them
A02G0IA
TYPICAL 1Parallel with steering arm 2Steering arm
ADJUSTMENT
Steering Column Position Adjustment
Some Models
WARNING
The cut off section of the ball joint must run parallel with the swivel bar no9When tightening lock nuts, restrain ball joint with appropriate size wrenchThe maximum external threaded length not engaged in the tie rod must not exceed 20 mm (2532 in)
WARNING