2005 Ski-Doo RT Series Shop Manual, Page 335Get this manual
Section 11 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Cut both locking ties that secure the harness to the housing
Insert the probe into the housing as shown, and locate the appropriate wire in the back of the housingYou may have to slightly cam the probe against the locking tab to release it, then remove the terminal from the housing
F18Z0UA F18Z07A
1Locking ties
Turn the housing over and remove the lock by pushing and then pulling toward the wire harness
F18Z0VA
F18Z0SA