2005 Ski-Doo RT Series Shop Manual, Page 315Get this manual
Section 09 BODYFRAME Subsection 01 (BODY)
Cover Replacement
Remove the old seat coverCheck the foam and replace it if necessaryInstall staples with an electric tacker such as Arrow tacker ETN-50 or with manual tacker such as Arrow tacker T-50NOTE: For an easier installation, it is highly recommended to use an electric tackerEnsure that the seat rest firmly against hard surface such as piece of woodThis is done to get the staples completely pushed in place
CAUTION: The following products must not be used to clean or wax any of the plastic components used on the vehicles: gasoline brake fluid kerosene diesel fuel lighter fluid varsol naphtha acetone strong detergents abrasive cleaners waxes containing an abrasive or cleaning agent in their formulaApply wax on glossy finish onlyProtect the vehicle with cover to prevent dust accumulation during storageCAUTION: If for some reason the snowmobile has to be stored outside, it is preferable to cover it with an opaque tarpaulinThis will prevent the sun rays from affecting the plastic components and the vehicle finishA35H0HA