2005 Ski-Doo RT Series Shop Manual, Page 291Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
MODEL Models with straight grips Models with J-hooks
TOOL PART NUMBER 529 035 897 529 035 936
A33G0FA
1Connectors unplugged
Unplug LH harness on top of steering columnCut locking ties retaining brake light switchheating grip harness to handlebarUsing the multilock-terminal housing extraction tool AMP (PN 755430-2), push the wires of the heating grip harness out of connector housingNote the position of the wires for reinstallationPull heating grip wires out of brake light switch heating grip harnessInsert the open side of 23 mm (78 in) wrench against the inner end of gripCAUTION: Pay attention not to damage wires with the wrenchUsing plastic hammer, tap on the side of the wrench end to make the grip sliding outGrip Installation: Installation is the opposite procedure of the removal but pay attention to the followingClean handlebar ends and inside of heating grip with isopropyl alcoholLet dry before installation