2005 Ski-Doo RT Series Shop Manual, Page 284Get this manual
Section 07 REAR SUSPENSION Subsection 03 (SHOCK ABSORBER INSPECTION AND SERVICING)
NOTE: Although we do not measure the exact amount of oil added to the damper, approximately 252 mL (8.52 ozU.S will be usedCarefully insert damper rod into the damper bodyLightly oil damper piston seal ring with shock oil to ease installation
Screw Cap Type HPG TA Shock Seal carrier assembly can now be threaded into damper bodyThis should be done slowly to allow weapage of oil and to minimize IFP displacementTorque seal carrier to 90 to 100 Nm (66 to 74 lbfft)Snap Ring Cap Type HPG TA Shock Seal carrier assembly can now be pushed into damper body to pass snap ring groveInstall snap ring into grooveTap the cap on the shock bodyAll HPG TA Shocks After the seal carrier is fully in place avoid pushing the shaft into the body until the nitrogen charge is added529 035 727
A06F16A