2005 Ski-Doo RT Series Shop Manual, Page 251Get this manual
Section 06 DRIVE SYSTEM Subsection 08 (TRACK)
To correct, stop engine, loosen rear wheel screws, then tighten the adjustment screw on side where the slider shoe is the farthest from the track insert guides1 1
A01F0BA A01B4UA
1Guides 2Slider shoes 3Tighten on this side
TYPICAL 1First step 2Second step (to push tabs into rubber)
Restart engine, rotate track slowly and recheck alignmentIf the satisfactory alignment is achieved, then tighten the idler wheel retaining screws to 48 Nm (35 lbfft)Reinstall the wheel caps