2005 Ski-Doo RT Series Shop Manual, Page 250Get this manual
Section 06 DRIVE SYSTEM Subsection 08 (TRACK)
Allow the rear suspension to fully extend and check gap halfway between front and rear idler wheelsMeasure between slider shoe bottom and inside of trackThe gap should be as given in SPECIFICATIONSIf the track tension is too loose, track will have tendency to thumpNOTE: The belt tension tester (PN 414 348 200) may be used to measure deflection as well as force applied
A00C07C
BELT TENSION TESTER
A30F03A
TYPICAL 1Adjustment screw 2Retaining screw 3Wheel cap removal
Alignment WARNING
Before checking track alignment, ensure that the track is free of all particles which could be thrown out while track is rotatingKeep hands, tools, feet and clothing clear of trackEnsure no one is standing in close proximity to the vehicleNever rotate at high speedStart the engine and accelerate slightly so that track barely turnsThis must be done in short period of time (1 to minutes)Check that the track is well centered; equal distance on both sides between edges of track guides and slider shoes1 2