2005 Ski-Doo RT Series Shop Manual, Page 230Get this manual
Section 06 DRIVE SYSTEM Subsection 05 (BRAKE)
Remove the Banjo bolt no4 and discard the sealing rings no5Unscrew master cylinder screws no6 from the master cylinder holder no7 then remove master cylinder from handlebar
Inspection
Check master cylinder for cracks or leakageReplace if necessary
A35D04A
1Slot on pad lining ABrake pad minimum thickness mm (132 in)
Installation
The installation is essentially the reverse of the removal procedure but pay attention at the followingInstall the master cylinder holder no7 with the arrow pointing downwards