2005 Ski-Doo RT Series Shop Manual, Page 218Get this manual
Section 06 DRIVE SYSTEM Subsection 03 (DRIVEN PULLEY)
On threaded rod install both sleeves and one spacer included with the clutch spring compressor (PN 529 036 012)
A35D19A
A35D17A
Place the large bushing extractor (PN 529 035 575) below bushing and screw the threaded rod of the clutch spring compressor (PN 529 036 012) in the large bushing extractor hole until the end of threaded rod reaches against the support plate
Coat bushing outside diameter with Loctite 380 (Black MAX) (PN 413 408 300)Place new bushing on sliding half and slightly tap to engage squarely the bushing in the slidingInstall the sliding pulley on threaded rod and screw in the large bushing extractor (PN 529 035 575)A35D1AA
A35D18A