2005 Ski-Doo RT Series Shop Manual, Page 207Get this manual
Section 06 DRIVE SYSTEM Subsection 02 (DRIVE PULLEY) A32D2YA A32D2WA
1Bushing
Clean sliding half bushing mounting surface with pulley flange cleaner (PN 413 711 809)To install new bushing, secure the spring compressor (PN 529 035 524) in vice and mount the sliding half Apply Loctite 609 (PN 413 703 100) on the outside of bushing face then insert the bushing from inner side of sliding halfMount the sliding half bushing removerinstaller (PN 529 035 931) with side marked "IN" to press in new bushing
Install the circlip
A32D2ZA
TYPICAL 1Circlip
Spring Cover Bushing Replacement Under normal use there is no need to replace this bushing no15In case of replacement, it's recommended to replace spring cover assemblyA32D2XA