2005 Ski-Doo RT Series Shop Manual, Page 204Get this manual
Section 06 DRIVE SYSTEM Subsection 02 (DRIVE PULLEY)
To separate fixed half no4 from sliding half no8, heat the stop plate with heat gun then screw puller into fixed half shaft about 13 mm (12 in)Raise drive pulley and hold it by the sliding half while knocking on puller head to disengage fixed half
529 005 500
A16B02A
TYPICAL
When all slider shoes are hold with the forks, remove the governor cup
Spring Cover
A16D01A
TYPICAL 1Puller 2Holding sliding half
To remove the spring cover no10, always use the spring compressor (PN 529 035 524)The spring cover is pushed by clutch spring pressure