2005 Ski-Doo RT Series Shop Manual, Page 193Get this manual
Section 05 ELECTRICAL SYSTEM Subsection 05 (ACCESSORIES AND LIGHTING SYSTEM)
Disconnect headlampsOn RH side of vehicle, remove the push nut then remove the headlamp housing
HEATING ELEMENTS
NOTE: All measurements must be performed at 21C (70F)
Installation
Reverse the removal procedure
Throttle Lever Heating Element
Resistance Measurement
THROTTLE LEVER HEATING ELEMENT
TEST WIRE COLOR RESISTANCE NOTE High Intensity BROWN and YELLOWBLACK 1.73 to 4.22 Low Intensity BROWNYELLOW and YELLOWBLACK 5.73 to 18.54
HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayPlace the vehicle on flat surface perpendicular to test surface (wall or screen) and 381 cm (12 ft in) away from itRider or equivalent weight must be on the vehicleSelect high beamMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed line