2005 Ski-Doo RT Series Shop Manual, Page 191Get this manual
Section 05 ELECTRICAL SYSTEM Subsection 05 (ACCESSORIES AND LIGHTING SYSTEM)
Installation
To install beeper, reverse the removal procedureCheck connectors positionENGINE TEMPERATURE GAUGE
Check fuse, connectors and harnessCheck the condition of relay by using the BUDS softwareCheck temperature sensorReplace the gauge
A32E3RA
Removal
Remove the accessories panelRemove the ring around the gauge by pressing both tabsUnscrew the central nut and remove the supportUnplug connectorRemove gauge
1REDGREY wire on positive tab 2BEIGEBLACK wire on negative tab
Using jumper wires, connect battery positive post to beeper positive tabConnect battery negative post to beeper negative tabSee next photoCAUTION: To avoid beeper damage, ensure that polarity is respected