2005 Ski-Doo RT Series Shop Manual, Page 169Get this manual
Section 04 ENGINE MANAGEMENT (SDI) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
NOTE: If no fault code is displayed in B.U.D.S the E-RAVE actuator can still be faultyIt could be mechanical problemIf actuator overheating occurs, fault code P0078 will appearIt could be caused by mechanical problems such as overtighten cables or damaged pulleysIf communication problem occurs between ECM and actuator, fault code P0600 will appearIt could also be caused by not-powered actuator
If no power goes to the E-RAVE actuator, no communication can take placeIf B.U.D.Sworks, it validates the ECM works and can communicateTherefore the problem is in the wires going to the E-RAVE actuatorCheck continuity of wires V-3 and V-5If continuity is faulty, repair wiringconnectorIf continuity is good, try new actuator
Dynamic Test, Replacement and Cable Adjustment
Refer to RAVE system
Voltage Test
Remove the headlight relay (R2)NOTE: To prevent battery discharge, headlight fuse (F8) can be removedBypass relay with jumper1 2