2005 Ski-Doo RT Series Shop Manual, Page 160Get this manual
Section 04 ENGINE MANAGEMENT (SDI) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
Mechanical Inspection
Check that the throttle plate moves freely and smoothly when depressing throttle leverIMPORTANT: The throttle body is designed to be tamper proofChanging the zero position stop screw or synchronization screw or modifying them in any way will not increase performance but may cause poor startability and erratic idlingBefore replacing any part, check the following as these could be causing the faultPerform the test while the engine is not running Throttle cable adjustment too tightNot returning fully to idle stop Throttle body idle set screw is loose or worn Throttle plate is loose, worn or damaged TPS is loose Corroded or damaged wiring or connectors Throttle body has been replaced and the Closed Throttle reset has not been performed ECM has been replaced and the Closed Throttle reset has not been performed
A35C3WA
1Throttle body 2Clamp
Slightly pull throttle body outInstallation Installation of the new throttle body is the reverse of the removal procedurePay attention to the following detailsMake sure that the retaining clamps are positioned as shown in the following illustration