2005 Ski-Doo RT Series Shop Manual, Page 88Get this manual
Section 02 ENGINE Subsection 08 (BOTTOM END)
NOTE: During installation support the ceramic seal using the ceramic seal installer (PN 529 036 014) as shown on the following illustration1 7
A35C1HA
Reinstall oil injection pump2 3
INSPECTION
Refer to table below to find bottom end engine dimension specificationsFor dimension measurement procedures, refer to ENGINE MEASUREMENTENGINE MEASUREMENT Crankshaft deflection on PTO side Crankshaft deflection on MAG side Crankshaft deflection in center of crankshaft Connecting rod big end axial play Crankshaft end-play TOLERANCES NEW PARTS (min (max N.AN.AN.A0.23 mm (.009 in) 0.10 mm (.004 in) 0.03 mm (.0012 in) 0.05 mm (.002 in) 0.08 mm (.0031 in) 0.62 mm (.024 in) 0.30 mm (.012 in) WEAR LIMIT 0.06 mm (.0025 in) N.AN.A1.20 mm (.047 in) N.A