2005 Ski-Doo RT Series Shop Manual, Page 84Get this manual
Section 02 ENGINE Subsection 08 (BOTTOM END)
Counterbalance Drive Gear
NOTE: To removeinstall bearing no6 and gear no7 from crankshaft, refer to specialized shopSpecial tools and accurate procedures are requiredCAUTION: Do not attempt to remove inner bearing or gearGear could be damaged
CoolantInjection Oil Pump Shaft
Removal NOTE: It is not necessary to split up crankcase halves to pull out shaftRemove: Injection oil pump Coolant pump housing no10A32CARA
1Half ring 2Puller ring
NOTE: Apply grease on crankshaft end in order to hold in place the crankshaft protector (PN 420 876 552) on PTO side and crankshaft protector (PN 420 876 557) on MAG sideUsing screws (PN 420 840 681), install bearing puller (PN 529 036 004) on the half ringsSecure the bearing puller in vise by one of its ribA35C1BA