2005 Ski-Doo RT Series Shop Manual, Page 59Get this manual
Section 02 ENGINE Subsection 05 (MAGNETO SYSTEM)
GENERAL
NOTE: The following procedures can be done without removing the engineTo facilitate magneto removal, hold drive pulley with the appropriate toolDuring assemblyinstallation, use the torque values and service products as in the exploded viewsClean threads before applying threadlockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (e.g locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewedA32C8KA
TYPICAL
Install the puller ring (PN 529 036 001) in magneto housing openingCAUTION: Use only M8 20 mm screws to bolt puller to magneto flywheel