2005 Ski-Doo REV Series Shop Manual, Page 496Get this manual
Section 13 WIRING DIAGRAM Subsection 01 (WIRING DIAGRAMS)
Insert the probe into the housing as shown, and locate the appropriate wire in the back of the housingYou may have to slightly cam the probe against the locking tab to release it, then remove the terminal from the housing
When re-inserting the connector, the locking tab must be installed facing the smaller cutout of the connector cavity
F18Z0UA F18Z0XA
Insert the connector, ensuring the locking tab snaps into the housingRe-install the lock, attach the tie raps, and close the housing coverTerminal Crimping (Kostal and AMP multilock) To crimp new connector terminal, use the connector crimping tool (PN 529 035 909) and the crimper die (PN 529 035 906)F18Z0VA