2005 Ski-Doo REV Series Shop Manual, Page 460Get this manual
Section 10 STEERINGFRONT SUSPENSION Subsection 02 (FRONT SUSPENSION)
To properly torque ball joint nut, use the A-arm nut wrench (PN 529 035 876)
A33F2AA
529 035 876
Ensure to install the tool perpendicularly (90) to torque wrench1 A
A33F2IB
Lower Arm
Position lower arm below stabilizer barPrior to installing ball joint in lower arm, ensure to clean the tapered surfaces with the pulley flange cleaner (PN 413 711 809)Surface contacts must be clean and free of dirt, oil and greaseApply the cleaner on rag then use the rag to clean the surfaces of ball joint and ski legTo install ball joint, proceed as follows: Install ball joint support (PN 529 035 875) on top side of lower arm (operating position) Position ball joint installer (PN 529 035 975) on bottom side of lower arm (operating position) Press joint in Install snap ring no13 with its opening toward front of vehicleA33F22A