2005 Ski-Doo REV Series Shop Manual, Page 449Get this manual
Section 10 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
Procedure: Position handlebar so that it is in straight ahead position by measuring from the extremities of the grips to the rear most edge of the tunnel, as shownNOTE: The reference point must be the same relative to each side
A33G0IA
TYPICAL 1Straight edge 2Rubber cord 3Measure at rear and front of ski bridge
adjustment is needed: Loosen jam nuts of both tie rods no11Turn the tie rod to change its lengthRetighten jam nuts