2005 Ski-Doo REV Series Shop Manual, Page 425Get this manual
Section 09 REAR SUSPENSION Subsection 03 (SC SUSPENSION)
At installation, rear arm stroke limiter must be on rear sideInsert dowel pin into pivot arm hole, dowel pin must exceed block guide by to 2.3 mm (.079 to .091 in)Respect the following tightening torque specificationsDESCRIPTION Pivot armrunners nut Locking ring set screw TIGHTENING TORQUE 25 Nm (18 lbfft) 2.5 Nm (22 lbfin)
A33F5ZA
1RH side wheels position 2LH side wheels position
BLOCK INSTALLATION
Both blocks are identified or (right or left) and have position number (from to 4)At installation make sure to install proper block on proper side with the same adjustment position on both sides