2005 Ski-Doo REV Series Shop Manual, Page 418Get this manual
Section 09 REAR SUSPENSION Subsection 03 (SC SUSPENSION)
AXLE SELF-LOCKING SCREW REMOVAL
CAUTION: These self-locking screws must always be replaced by new ones everytime they are removedNOTE: To prevent an axle from turning when unscrewing self-locking screws, proceed as follows: Remove one self-locking screw then install 10 mm shorter non-self-locking one in placeTorque as specified in exploded view Remove the opposite self-locking screw Remove the temporary installed non-self-locking screw If it doesn't work, heat bolt head to melt threadlockerA33F5IA
ON BOTH SIDES 1Remove the following
REAR AXLE REMOVAL
Lift rear of vehicle and support it off the groundRemove screws on rear axleCompletely loosen track tension