2005 Ski-Doo REV Series Shop Manual, Page 289Get this manual
Section 06 ENGINE MANAGEMENT (SDI) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
For primary winding, check the resistance between terminal 15 and terminal 1a (cylinder 1) of the ignition coil and between terminal 15 and terminal 1b (cylinder 2) respectivelyThe resistance should be between 0.40 and 1.15 at 20C (68F)If the resistance of one of both windings is not good, replace the ignition coilIf the windings test good, try new ECM
BATTERY TYPE YT4L-BS
STANDARD CHARGE 0.3 Ampshour for to 10 hours
QUICK CHARGE 3.0 Ampshour for 30 min
Electric Start Models Refer to CHARGING SYSTEM section for the charging procedure of the battery
WARNING
Always reconnect ignition coil cables at the same spark plugs where they come fromOtherwise, severe backfire may occur with possible damage to exhaust system components
CAPACITOR
Manual Start Models
WARNING