2005 Ski-Doo REV Series Shop Manual, Page 235Get this manual
Section 05 ENGINE MANAGEMENT (POWER TEK) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
Validation of Pins and Reconnect ECM connectorConnect voltmeter between pin and in TPS connector of wiring harnessVoltage should be VOtherwise, disconnect ECM connector and check continuity of wires between TPS connector and ECM connector17 32
A33C51A
1Idle screw 2Throttle lever stopper AGap required here
A34E0LB
Activate throttle lever times to make sure throttle slides are fully closedUsing multimeter, check resistance values as per the following table1
ECM CONNECTOR PIN ECM CONNECTOR DA-22 DA-1 22 22 PIN THROTTLE IDLE POSITION 3680 5520 4000 6000 480 720 WIDE OPEN THROTTLE POSITION 480 720 4000 6000 3680 5520
ECM CONNECTOR