2005 Ski-Doo REV Series Shop Manual, Page 206Get this manual
Section 04 FUEL SYSTEM Subsection 02 (CARBURETORS, THROTTLE AND CHOKE CABLES)
Pilot Jet
Use narrow screwdriver from carburetor tool kit (PN 404 112 000) to unscrew pilot jet no7
Throttle Slide WARNING
It is critical to the free operation of the throttle slide that the connecting plates as assembled in one carburetor be of the exact same lengthAlways replace the connecting plates by pair of new ones that were matched at the factory for length and discard the old onesSimultaneously replace all the plates of the carburetors of same rackDo not disassemble throttle slide no17 needlesslyCAUTION: After throttle slide reassembly, proceed with leak testSee below for procedureDisassemble both carburetors at the same timeCoolant hose between carburetor throttle slide covers must remain in place during the complete disassembly and assemblyRemove carburetor coverLoosen needle retainer screw no8Fully open throttle and hold in this position for the following stepMove aside needle retainer no9.A32C2OA