2005 Ski-Doo REV Series Shop Manual, Page 132Get this manual
Section 03 ENGINES Subsection 06 (BOTTOM END)
INSPECTION
Refer to table below to find bottom end engine dimension specificationsFor dimension measurement procedures, refer to ENGINE MEASUREMENTENGINE MEASUREMENT Crankshaft deflection on PTO side Crankshaft deflection on MAG side Crankshaft Deflection in center of crankshaft Connecting rod big end axial play Crankshaft end-play TOLERANCES NEW PARTS (min (max N.AN.AN.A0.2 mm (.007 in) 0.10 mm (.004 in) 0.06 mm (.0024 in) 0.03 mm (.001 in) 0.08 mm (.0031 in) 0.53 mm (.026 in) 0.30 mm (.012 in) WEAR LIMIT N.AN.AN.A1.20 mm (.047 in) N.A
A32CB3A
BEARING PULLER SECURED IN THE VISE
CAUTION: Never use any air impact tool for tightening the puller boltLubricate the puller bolt and then proceed with tightening the puller bolt until the bearing comes outFollow the same procedure for the inner bearingNOTE: In the case of damaged bearing or less clearance between crankshaft counterbalance and the bearing or on the MAG side bearing, use bearing separator (SNAP-ON tool (PN CJ951 or SPXOTC) tool (PN 1124) to facilitate the removal