2005 Ski-Doo REV Series Shop Manual, Page 80Get this manual
Section 03 ENGINES Subsection 03 (ENGINE REMOVAL AND INSTALLATION)
REMOVAL FROM VEHICLE
Vehicule and Engine Preparation
Place vehicle at workstation that will have access to an engine-lifting hoistThen start with initial preparation of vehicle by doing the followingRemove the RH and the LH side panelsDisconnect BLACK (-) cable from battery, then the RED (+) cable
WARNING
Always disconnect battery or starter cables exactly in the specified order, BLACK (-) cable firstIt is recommended to disconnect electrical connections prior to disconnecting fuel linesFrom the front of vehicle Remove tuned pipe and manifold, refer to EXHAUST SYSTEM1
A33C44A
Magneto connector Reverse connector Trigger coil connector Engine stop switch connector