2005 Ski-Doo REV Series Shop Manual, Page 23Get this manual
INTRODUCTION
If plate is used to align bolt: Apply release agent on mating surfaces Put waxed paper or similar film on the surfaces Twist bolt when inserting it to improve thread conformationNOTE: NOT intended for engine stud repairsRepair of Small HolesFine Threads Option 1: Enlarge damaged hole, then follow STANDARD THREAD REPAIR procedureOption 2: Apply FORM-A-THREAD on the screw and insert in damaged holePermanent Stud Installation (light duty) Use stud or thread on desired length DO NOT apply release agent on stud Do STANDARD THREAD REPAIR Allow to cure for 30 minutes Assemble
Spray Loctite Primer on both mating surfaces and on both sides of gasketAllow to dry or minutes Apply GASKET ELIMINATOR 515 (PN 413 702 700) on both sides of gasket, using clean applicator Place gasket on mating surfaces and assemble immediatelyNOTE: If the cover is bolted to blind holes (above), apply proper strength Loctite in the hole and on threadsTightenIf holes are sunken, apply proper strength Loctite on bolt threads Tighten as usual