2004 Skidoo ZX Series Service Manual, Page 519Get this manual
Section 11 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
Unplug all connector housing of handlebar switchesUnscrew all bolts no10 securing handlebar
TILT HANDLEBAR MECHANISM (IF SO EQUIPPED)
Removal
Move handlebar no1 to its higher positionRemove Allen screw retaining locking lever no8Pull out locking leverRemove steering padUnhook throttle cable from throttle leverUnscrew all bolts no10 securing handlebarNOTE: Do not unbolt master cylinder needlesslyMove handlebar apart, keeping master cylinder reservoir in upward position
Installation and Adjustment
For the installation, reverse the removal procedureTo adjust the handlebar, the bolts no10 must be loosedPosition the handlebar to the desired position then lock it in place by tightening the nuts no11