2004 Skidoo ZX Series Service Manual, Page 509Get this manual

2004 Skidoo ZX Series Service Manual, Page 509

Section 10 REAR SUSPENSION Subsection 04 (TRACK)
Restart engine, rotate track slowly and recheck alignmentIf the satisfactory alignment is achieved, then tighten the idler wheel retaining screws to 48 Nm (35 lbfft)Reinstall the wheel caps
Track Cleat
Removal Raise rear of vehicle off the ground and lift snow guard then hand rotate track to expose cleat to be replaced Using track cleat remover (PN 529 028 700) for all modelsInstallation Place new cleat in position on the track and using narrow track cleat installer (PN 529 008 500) bend cleat then push tabs into rubber Re-open installer, then position cleat tabs on open end of tool and squeeze tabs until they are indented in rubberA01B4UA