2004 Skidoo ZX Series Service Manual, Page 482Get this manual
Section 10 REAR SUSPENSION Subsection 01 (SC-10 SUSPENSION)
COMPONENT REMOVAL AND INSTALLATION
Lift rear of vehicle and support it off the ground
21, Rear Axle
Remove screw on rear axle on side of offset wheelCompletely loosen track tensionPull out rear axle from opposite side of offset inner wheelAt assembly, align spacer hole with adjusting boltMake sure to reinstall washer on each side of runner529 005 000
A03F2FA
A03F1LA
Remove nut on top end of shockRemove nut on bottom end of shockPry up shock bottom end to ease removing bolt (gas shock only)See installation illustration belowInstallation is reverse of removal procedureTo easily compress gas shock absorber, use pry bar and locking pliers as stopperCAUTION: Take care not to damage grease fitting1 2