2004 Skidoo ZX Series Service Manual, Page 459Get this manual
Section 09 ELECTRICAL SYSTEM Subsection 05 (ELECTRIC STARTER)
After placing collar no3 on armature shaft no11, fit new snap ring no2 on armature shaft, then make sure that it is properly securedSlide collar no3 over snap ring no2 and secure in place by punching it at two or three places
A32E23A
1Brush holder
A03E0EA
Armature shaft Snap ring Collar Punch
To ease end frame installation, retain brush holder with small screwdriver while installing armature assemblyCAUTION: Make sure to place two end housings on flat surface before tightening the through boltsCAUTION: Make sure end frame fits perfectly on yoke