2004 Skidoo ZX Series Service Manual, Page 453Get this manual
Section 09 ELECTRICAL SYSTEM Subsection 05 (ELECTRIC STARTER)
Insert blade of small screwdriver between stop collars
A19E0BA
A19E01A
Press-in Bushing pusher Bushing Drive housing
TYPICAL
Twist screwdriver to separate stop collars no12 thus giving access to circlip no13Remove outer collar, circlip then inner collarRemove overrunning clutch no11Check the wear on bushing no18 by measuring the amount of radial play between the armature shaft and the bushingThe radial play should not exceed 0.20 mm (.008 in)If greater, replace the bushingTo replace, press out the old one toward bushing cover and press in new one with bushing pusherThe correct size of the bushing pusher to use is given on next illustrationCAUTION: Support drive housing adequately to prevent damage when pressing bushingA