2004 Skidoo ZX Series Service Manual, Page 416Get this manual
Section 08 TRANSMISSION Subsection 05 (BRAKE)
Apply anti-seize lubricant (PN 293 800 070) on shaft and check that disc slides freelyThe disc hub exceeds the disc more from one side than from the otherInstall disc with the longer exceeding portion toward driven pulleyPush O-rings inside disc hub
529 035 699
COUNTERSHAFT BEARING
Removal
Unbolt bearing support no15Install screw from remover (PN 529 035 699)529 035 699
A30D1GB
TYPICAL 1Bearing
Installation
Insert countershaft (with brake disc) from chaincase side through countershaft support (driven pulley side), then insert into chaincaseInstall countershaft bearing no17 using proper toolTo install bearing on countershaft, use remover (PN 529 030 100) and some flat washers of mm (18 in) total thicknessUsing original retaining screw and shouldered washer tighten until bearing rests against circlip